ULTRACOAT P925


Two-component, water-based polyurethane varnish, with an extremely low emission level of volatile organic compounds (VOC) and no NMP, highly resistant to wear and abrasion, for wooden floors. Suitable for floors subject to extremely high pedestrian use.

Where to use:
Highly protective and wear and abrasion-resistant finish on traditional and pre-sanded wood, and wooden floors requiring repair. It may be used in civil and commercial environments subject to extremely high pedestrian use (public offices, shopping centres, airports, exhibition halls, etc.)
Ultracoat P925 has excellent resistance to abrasion and skid marks, which has never been possible with other water-based products. It leaves the parquet with an attractive “natural” finish. Floors treated with this varnish have a natural, even finish, and may be cleaned very easily, as with impregnation cycles which require the use of oil and wax. If it is applied directly without a base product, it livens up the colour of the parquet without yellowing over the years.
A single coat applied directly on top of Ultracoat P920 2K or Ultracoat P920 S-T base products is usually enough to complete the varnishing cycle. The three-coat cycle is recommended in environments subject to intense traffic. As an alternative, Ultracoat P925 may be applied directly on the floor instead of the base coat.
Ultracoat P925 is available in extra opaque (10 gloss – Ultracoat P925/T), opaque (30 gloss – Ultracoat P925/0) and satin finish (60 gloss – Ultracond P925/0).

Technical data:
Consistency: comp. A liquid; comp. B liquid.
Colour: comp. A transparent; comp. B whitish.
Gloss factor: extra opaque (10 gloss), opaque (30 gloss) and satin finish (60 gloss).
Inflammable: no.
Recommended application temperature range: from 10°C to 35°C.
Pot life of mix: 2 hours.
Mixing ratio: comp. A : comp. B = 10 : 1 (in volume).
Maximum permitted dilution ratio (Dir. 2004/42/CEE): 10% with clean water or Ultracoat EL.
Sanding: after 12 hours.
Painting: after 3 hours, and within 5 hours.
Ready for use: 36-48 hours.
Storage: 12 months.
Application: by roller (Ultracoat Roller Plus or Ultracoat Roller Finish, according to whether it is the first coat or the following coats) or brush.

Consumption
70-90 g/m2 per coat.

Packaging
11 l units (A B).

ULTRACOAT P925 is part of the lines:

Related documentation

Technical data sheet
Download

Last Projects ULTRACOAT P925

Category icon PUBLIC BUILDINGS AND URBAN DESIGN

Kultúrny dom - Studenec

Studenec, Slovakia

Installation of floors

Category icon TOURISM AND WELLNESS

Mistral Hotel

Gniewino, Poland

Installation of floors

Category icon PUBLIC BUILDINGS AND URBAN DESIGN

2011

Centennial Hall

Wrocław, Poland

Installation of floors

Category icon COMMERCIAL FACILITIES

Porta Carlo Magno

Milan, Italy

Installation of floors

Keep in touch

Subscribe to our newsletter to get Mapei news