ULTRACOAT P915

One-component, water-based polyurethane varnish, with extremely low emission levels of volatile organic compounds (VOC) and no NMP, highly resistant to wear and abrasion, for wooden floors. Suitable for floors subject to frequent pedestrian use.
Where to use:
Highly protective, wear and abrasion-resistant finish for traditional wooden floors for civil and commercial use, both pre-sanded and those requiring repair.
Ultracoat P915 has excellent resistance to abrasion and skid marks. It is aesthetically different from conventional water-based products, in that it is transparent and leaves a warm-coloured finish to the wood.
We recommend a three-coat cycle using Ultracoat P915 or, as an alternative, a first coat of Ultracoat P920 2K or Ultracoat P920 S-T, two-component, water-based base products followed by one or two coats of Ultracoat P915.
Ultracoat P915 is available in extra opaque (10 gloss- Ultracoat P915/T), opaque (30 gloss- Ultracoat P915/O) and satin finish (60 gloss- Ultracoat P915/S).
Technical data:
Consistency: liquid.
Colour: transparent.
Gloss factor: extra opaque (10 gloss), opaque (30 gloss) and satin finish (60 gloss).
Inflammable: no.
Recommended application temperature range: from +10°C to +35°C.
Maximum permitted dilution ratio (Dir. 2004/42/CEE): 10% with clean water or Ultracoat EL.
Sanding: after 8 hours.
Painting over with no sanding: after 3 hours, and within 5 hours.
Ready for use: 36-48 hours.
Storage: 12 months.
EMICODE: EC1 - very low emission.
Application: by roller (Ultracoat Roller Plus or Ultracoat Roller Finish, according to whether it is the first coat or the following coats) or brush.
Consumption
70-90 g/m2 per coat.
Packaging
5 l cans.