MAPEFLOOR I 300 SL

High-performance formulation for epoxy-resin based systems used to create seamless surfaces in industrial, commercial and residential settings, rapid installation, durable and resistant with an attractive finish.

MAPEFLOOR I 300 SL

High-performance formulation for epoxy-resin based systems used to create seamless surfaces in industrial, commercial and residential settings, rapid installation, durable and resistant with an attractive finish.

HIGH RESISTANCE TO WEAR AND ABRASION

HIGHLY ATTRACTIVE FINISH

RAPID INSTALLATION

NON-SLIP OR SMOOTH FINISH

MAPEFLOOR I 300 SL is an epoxy formulation by Mapei for epoxy resin-based systems used to create industrial flooring.
May be used for:

multi-layered industrial flooring (Mapefloor System 31 and Mapefloor System 32), self-levelling industrial flooring (Mapefloor System 33), mortar-based industrial flooring (Mapefloor System 91)

These systems are recommended for both new flooring and for restoring old flooring. Suitable for application in industrial and commercial settings, such as:

chemical industry, pharmaceutical, food and drinks industries, mechanical engineering industry, automated warehouses and stores, logistics hubs, shopping centres, laboratories

To verify the feasibility of the work or the most suitable product request a consultation from our Technical Services Division

MAPEFLOOR I 300 SL

Two-component, multi-purpose, neutral-coloured epoxy formulate for industrial floor coatings up to 4 mm thick.
May be coloured with MAPECOLOR PASTE.
Complies with standards applied in the foodstuffs sector.

ADVANTAGES:

Non-slip or smooth finish.
High resistance to wear and abrasion
Rapid installation
Highly attractive finish
High solids content
Easy to clean and sanitise
Resistant to most diluted chemicals

TECHNICAL DATA:
Mixing ratio: comp. A : comp. B = 3 : 1.
Colour of mix: neutral.
Consistency of mix: fluid.
Dust dry at +23°C and 50% R.H.: 2-4 hours.
Set to light foot traffic at +23°C and 50% R.H.: 24 hours.
Final hardening time: 7 days.
Taber Test after 7 days (EN ISO 5470-1) CS17 disk, 1000 cycles, 1000 g at +23°C - 50% R.H.: 70 mg.
Storage: 24 months in its original sealed packaging.
Application: by roller or flat or notched trowel.
Consumption:
– 2.0 kg/m² for 2 mm thick self-levelling coatings on substrates primed with PRIMER SN;
– 0.9 kg/m² for intermediate layers in 3 mm thick non-slip coatings on substrates primed with PRIMER SN;
– 0.6 kg/m² for finishing layers in 1 mm and 3 mm thick non-slip coatings on substrates primed with PRIMER SN.
Packaging: 20 kg kits (A+B).