Back

System for the structural restoration of concrete by applying high-flow mortar to be cast into formwork and protective elastomeric finish

Application steps

Discover the application steps, the products used for this solution and other alternative products.

1

Concrete

Completely remove all the areas of concrete at risk of becoming detached by mechanical means and remove all rust from the steel reinforcement.

2

Rebar passivating mortar MAPEFER 1K ZERO or MAPEFER

Thoroughly brush the steel bar and apply two coats of product with a brush to form a protective, anti-corrosion and re-alkalising layer at least 2 mm thick for the reinforcement rods.

3

Repairing mortar

MAPEGROUT HI-FLOW ZERO

Pour the mortar in a constant flow from one side only into the formwork, making sure that all the air is expelled. There is no need to vibrate the mortar after pouring.

4

Acrylic primer

MALECH

Apply the product with a brush, roller or by spray to even out the surface and promote adhesion of the successive coat of paint.

5

Hygienising, crack-bridging elastomeric paint

ELASTOCOLOR PITTURA ZERO

Once the primer is dry, apply the paint with a brush, roller or by spray. When applying with a brush or roller, 2 coats are required to ensure complete, effective hiding.