Back

Waterproofing new structures with membranes in total adhesion

Application steps

Discover the application steps, the products used for this solution and other alternative products.

1

Lean concrete

2

Synthetic membrane

MAPEPROOF FBT

Lay the synthetic membrane on the whole horizontal surface and fold it over the perimeter formwork. The sheets will overlap longitudinally and bond through the selfadhesive selvedge.

3

Concrete structure

4

Hydro-expanding acrylic profile

IDROSTOP

Apply the hydro-expanding acrylic profile in the midspan section of the construction joint using a polymer-sylilated base adhesive in cartridge.

5

Concrete wall.

6

Coving EPORIP + mortar MAPEGROUT 430 ZERO

Create a coving by applying the resin by brush and then connect using the mortar applied by trowel or putty knife, while the resin is still fresh, taking care to round off the shape of the mortar.

7

Primer MAPETHENE PRIMER/MAPETHENE PRIMER W

Apply the primer by brush, roller or airless spray on all vertical surfaces up to MAPEPROOF FBT applied under the sill plate.

8

Waterproofing membrane MAPETHENE HT / MAPETHENE LT

Apply one strip of membrane next to the joint between wall and foundation plinth by removing the protective film on the back. Then apply the waterproofing membrane from top to bottom by gradually removing the protective film and making it adhere to 1 Lean concrete the substrate until it overlaps with MAPEPROOF FBT applied under the sill plate.